Joining the Military

ASVAB Electronics Information Practice Test 1

Free · No signup

Test 1 of 5 for Electronics Information: 15 questions in 10 minutes, as on the computer test. None of its questions is in the other four tests.

Reviewed by Guilherme Correia, active-duty U.S. Air Force

1. Choose a test

2. Choose a version

Five versions, no question repeated between them. Take a new one each time so the score measures what you learned, not what you remember.

3. Choose the timing

Free, no signup. Your answers stay on this device.

Questions 8 to 14 of Electronics Information practice test 1

7 of the 15 questions in this test, exactly as the test asks them. Choose your answer, then open the answer under each one. The test above gives all 15, with an explanation like these for every question.

  1. 8. To measure the current through a lamp, an ammeter should be connected

    • A. between the lamp and a ground rod
    • B. in series with the lamp
    • C. directly across the battery
    • D. in parallel with the lamp
    Show the answer to question 8

    Answer: B. Parts in series carry the same current, so the ammeter is placed in series so that all of the lamp current passes through it. A voltmeter, not an ammeter, is connected in parallel because parts in parallel share the same voltage.

    Remember: Ammeter in series (current goes through it); voltmeter in parallel (across the part).

    Checked against OpenStax College Physics 2e, 21.4 DC Voltmeters and Ammeters.

  2. 9. On a schematic diagram, a battery is drawn as parallel lines of two different lengths. The longer line marks the

    • A. positive terminal
    • B. ground connection
    • C. negative terminal
    • D. internal resistance
    Show the answer to question 9

    Answer: A. In the battery symbol the longer line represents the positive terminal and the shorter line represents the negative terminal. Ground has its own separate symbol.

    Remember: Long line = positive (+), short line = negative (-).

    Checked against OpenStax Physics, 19.2 Series Circuits.

  3. 10. Most deaths from electric shock happen because the current

    • A. boils the water in the blood
    • B. throws the victim against a hard surface
    • C. burns through the skin at the point of contact
    • D. makes the heart beat irregularly (ventricular fibrillation)
    Show the answer to question 10

    Answer: D. Most electrical shock fatalities occur because the current puts the heart into ventricular fibrillation, a wildly irregular beating that stops blood circulation. Burns can occur at higher currents, but fibrillation is the main killer.

    Remember: Current through the chest can upset the heart rhythm; that is why the path from hand to hand or hand to foot is so dangerous.

    Checked against OpenStax College Physics 2e, 20.6 Electric Hazards and the Human Body.

  4. 11. A diode is a semiconductor device that

    • A. stores charge between two metal plates
    • B. steps AC voltage up or down
    • C. lets current flow in only one direction
    • D. measures the resistance of a part
    Show the answer to question 11

    Answer: C. A diode is made by joining p-type and n-type semiconductor material. It acts like a one-way valve: current flows easily when it is forward biased and almost not at all when it is reversed. Storing charge describes a capacitor.

    Remember: Think of a diode as a one-way valve for current.

    Checked against OpenStax University Physics Volume 3, 9.7 Semiconductor Devices.

  5. 12. In a properly installed three-wire household circuit, why is the neutral wire at about zero volts?

    • A. It is connected to earth ground at the power source and at the building
    • B. It passes through the circuit breaker before the outlet
    • C. Its insulation blocks the voltage from reaching it
    • D. It carries no current while an appliance is running
    Show the answer to question 12

    Answer: A. The neutral wire is connected to earth at the voltage source and at the user location, which forces it to zero volts relative to the earth. It still carries the return current, so "it carries no current" is wrong. The breaker sits on the hot wire.

    Remember: Hot wire brings the voltage; neutral is grounded and carries the current back; the ground wire protects the case.

    Checked against OpenStax College Physics 2e, 23.8 Electrical Safety: Systems and Devices.

  6. 13. In the circuit shown, a 12-volt battery feeds a 3-ohm resistor and a 6-ohm resistor connected in parallel. What total current does the battery supply?

    +12 VR1 = 3 ΩR2 = 6 Ω
    • A. 1.33 amperes
    • B. 2 amperes
    • C. 6 amperes
    • D. 4 amperes
    Show the answer to question 13

    Answer: C. Each parallel branch gets the full 12 volts: 12 / 3 = 4 A and 12 / 6 = 2 A, so the battery supplies 4 + 2 = 6 A. (The equivalent resistance is 2 ohms.) Adding the resistors as if in series gives 9 ohms and 1.33 A, which is wrong here.

    Remember: In parallel, every branch gets the full voltage; find each branch current and add them.

    Checked against OpenStax College Physics 2e, 21.1 Resistors in Series and Parallel.

  7. 14. A 60-watt lamp is left on for 50 hours. If electricity costs 15 cents per kilowatt-hour, what does the energy cost?

    • A. $4.50
    • B. $3.00
    • C. $450.00
    • D. $0.45
    Show the answer to question 14

    Answer: D. Energy is power times time: 60 W x 50 h = 3,000 watt-hours = 3 kilowatt-hours. At $0.15 per kWh the cost is 3 x 0.15 = $0.45. The $3.00 choice is the number of kilowatt-hours, not dollars, and $450.00 forgets to convert watts to kilowatts.

    Remember: Energy (kWh) = kilowatts x hours; cost = kWh x price per kWh.

    Checked against OpenStax College Physics 2e, 20.4 Electric Power and Energy.

What Electronics Information practice test 1 covers

15 questions in 10 minutes, the length and time limit of the Electronics Information subtest on the computer ASVAB. 3 of them are asked with a diagram. This subtest does not count toward your AFQT; it feeds the scores the services use for jobs. Test 1 spreads its questions over 12 topics:

TopicQuestions in test 1
Current, voltage and resistance1
Ohm's law1
Electrical power2
Series and parallel circuits2
AC and DC2
Components1
Magnetism and induction1
Meters and tools1
Schematic symbols1
Electrical safety1
Diodes and transistors1
Wire and wiring1

Questions and time limit: officialasvab.com, What to Expect, read October 3, 2026. The questions are original practice material; the topic names are this site's.

The other Electronics Information tests, and test 1 of the other subtests

What the Electronics Information subtest covers, how it is used and the questions people ask about it are on the Electronics Information practice test page. The format of all ten subtests and how the AFQT is scored are on the ASVAB practice test hub.

All five Electronics Information tests

Practice test 1 of the other subtests

Keep going

officialasvab.com (What to Expect), read October 3, 2026, for the number of questions and the time limit. The questions are original.

Results are estimates. Always verify with your finance office.

Reviewed by Guilherme Correia · Military Toolkit editorial

Military Toolkit is not affiliated with the Department of Defense or the ASVAB testing program. The questions are original practice material, not ASVAB questions.