Questions 1 to 8 of Electronics Information practice test 4
8 of the 15 questions in this test, exactly as the test asks them. Choose your answer, then open the answer under each one. The test above gives all 15, with an explanation like these for every question.
1. In a metal wire, the charges that actually move to carry the current are
- A. neutrons
- B. electrons
- C. protons
- D. positive ions
Show the answer to question 1
Answer: B. In metal wires, current is carried by electrons, which are negative charges. Conventional current is drawn in the direction positive charge would flow, which is opposite to the electrons. Neutrons have no charge at all.
Remember: In metals the movers are electrons; conventional current arrows point the other way.
Checked against OpenStax College Physics 2e, 20.1 Current.
2. A 24-volt source pushes a current of 3 amperes through a heater. What is the resistance of the heater?
- A. 0.125 ohm
- B. 8 ohms
- C. 21 ohms
- D. 72 ohms
Show the answer to question 2
Answer: B. Ohm's law rearranged gives R = V / I = 24 / 3 = 8 ohms. Multiplying the values (72) gives power in watts, not resistance.
Remember: R = V / I: ohms equal volts divided by amperes.
Checked against OpenStax College Physics 2e, 20.2 Ohm's Law: Resistance and Simple Circuits.
3. OSHA forbids wearing which of these if it might contact exposed energized parts?
- A. Safety glasses
- B. Rubber-soled work boots
- C. A metal ring or watch band
- D. A cotton work shirt
Show the answer to question 3
Answer: C. OSHA does not allow conductive jewelry and clothing, such as watch bands, bracelets, rings and key chains, where they might contact exposed energized parts, unless they are covered or otherwise made nonconductive. Metal can complete a circuit through the body and cause burns or shock.
Remember: Take off metal jewelry before electrical work; metal is a conductor.
Checked against OSHA 29 CFR 1910.333, Selection and use of work practices.
4. A fuse protects a circuit by
- A. raising the voltage when the current drops
- B. changing alternating current into direct current
- C. storing extra charge until it is needed
- D. melting and opening the circuit when the current is too high
Show the answer to question 4
Answer: D. A fuse contains a metal strip with a low melting point. Too much current overheats the strip, which melts and permanently breaks the circuit. A circuit breaker does the same job but can be reset.
Remember: Fuses melt and must be replaced; circuit breakers trip and can be reset.
Checked against OpenStax College Physics 2e, 20.6 Electric Hazards and the Human Body.
5. Alternating current is current that
- A. flows in one direction only
- B. never changes in strength
- C. periodically reverses direction
- D. comes only from batteries
Show the answer to question 5
Answer: C. Alternating current (AC) is the flow of charge that periodically reverses direction, as in household power. Flowing in only one direction at a steady value describes direct current (DC), such as from a battery.
Remember: AC alternates (back and forth); DC is direct (one way).
Checked against OpenStax College Physics 2e, 20.5 Alternating Current versus Direct Current.
6. In the circuit shown, two 6-ohm resistors are connected in parallel across a 12-volt battery. What is the current through each resistor?
- A. 2 amperes
- B. 1 ampere
- C. 4 amperes
- D. 6 amperes
Show the answer to question 6
Answer: A. In parallel, each resistor gets the full 12 volts, so each carries 12 / 6 = 2 amperes. The battery supplies the total, 4 amperes. Treating the resistors as series (12 ohms) gives 1 ampere, which is wrong here.
Remember: Parallel branches share the voltage, not the current; each branch current is V divided by that branch resistance.
Checked against OpenStax College Physics 2e, 21.1 Resistors in Series and Parallel.
7. How much electrical energy does a 2,000-watt heater use in 3 hours?
- A. 0.67 kilowatt-hour
- B. 6,000 kilowatt-hours
- C. 2 kilowatt-hours
- D. 6 kilowatt-hours
Show the answer to question 7
Answer: D. Energy is power times time. 2,000 watts is 2 kilowatts, and 2 kW x 3 h = 6 kilowatt-hours. The 6,000 choice is the answer in watt-hours mislabeled as kilowatt-hours.
Remember: Convert watts to kilowatts (divide by 1,000), then multiply by hours to get kWh, the unit on electric bills.
Checked against OpenStax College Physics 2e, 20.4 Electric Power and Energy.
8. In an analog meter, the needle is moved by
- A. heat that expands a metal strip
- B. the magnetic force on a current-carrying coil
- C. static charge that repels the needle
- D. air pushed by a tiny fan
Show the answer to question 8
Answer: B. The heart of most analog meters is a galvanometer. Current through its coil sits in a magnetic field, and the magnetic force on the current-carrying wire produces a needle deflection proportional to the current. A bending metal strip is how some circuit breakers work.
Remember: Galvanometer: current in a coil plus a magnet makes the needle turn, like a small motor held back by a spring.
Checked against OpenStax College Physics 2e, 21.4 DC Voltmeters and Ammeters.
What Electronics Information practice test 4 covers
15 questions in 10 minutes, the length and time limit of the Electronics Information subtest on the computer ASVAB. 2 of them are asked with a diagram. This subtest does not count toward your AFQT; it feeds the scores the services use for jobs. Test 4 spreads its questions over 12 topics:
| Topic | Questions in test 4 |
|---|---|
| Current, voltage and resistance | 1 |
| Ohm's law | 2 |
| Electrical safety | 1 |
| Components | 1 |
| AC and DC | 2 |
| Series and parallel circuits | 1 |
| Electrical power | 2 |
| Meters and tools | 1 |
| Schematic symbols | 1 |
| Magnetism and induction | 1 |
| Wire and wiring | 1 |
| Diodes and transistors | 1 |
Questions and time limit: officialasvab.com, What to Expect, read October 3, 2026. The questions are original practice material; the topic names are this site's.
The other Electronics Information tests, and test 4 of the other subtests
What the Electronics Information subtest covers, how it is used and the questions people ask about it are on the Electronics Information practice test page. The format of all ten subtests and how the AFQT is scored are on the ASVAB practice test hub.
