Joining the Military

ASVAB Electronics Information Practice Test 2

Free · No signup

Test 2 of 5 for Electronics Information: 15 questions in 10 minutes, as on the computer test. None of its questions is in the other four tests.

Reviewed by Guilherme Correia, active-duty U.S. Air Force

1. Choose a test

2. Choose a version

Five versions, no question repeated between them. Take a new one each time so the score measures what you learned, not what you remember.

3. Choose the timing

Free, no signup. Your answers stay on this device.

Questions 1 to 8 of Electronics Information practice test 2

8 of the 15 questions in this test, exactly as the test asks them. Choose your answer, then open the answer under each one. The test above gives all 15, with an explanation like these for every question.

  1. 1. Electric current is defined as the

    • A. opposition to the flow of charge
    • B. push that moves charge through a circuit
    • C. rate at which electric charge flows
    • D. energy stored in a battery
    Show the answer to question 1

    Answer: C. Current is the rate at which charge flows past a point, measured in amperes (one coulomb per second). The push that drives charge is voltage, and the opposition to it is resistance.

    Remember: Current = how much charge passes per second; voltage = the push; resistance = the opposition.

    Checked against OpenStax College Physics 2e, 20.1 Current.

  2. 2. A lamp with a resistance of 6 ohms carries a current of 2 amperes. What is the voltage across the lamp?

    • A. 12 volts
    • B. 0.33 volt
    • C. 8 volts
    • D. 3 volts
    Show the answer to question 2

    Answer: A. Rearranging Ohm's law gives V = I x R = 2 x 6 = 12 volts. Dividing 6 by 2 (3 volts) or adding the numbers (8 volts) does not follow Ohm's law.

    Remember: V = I x R: volts equal amperes times ohms.

    Checked against OpenStax College Physics 2e, 20.2 Ohm's Law: Resistance and Simple Circuits.

  3. 3. Under OSHA rules, what must be placed on each switch or disconnect used to shut off power to equipment before employees work on it?

    • A. A ground-fault outlet
    • B. A strip of electrical tape
    • C. A spare fuse
    • D. A lock and a tag
    Show the answer to question 3

    Answer: D. OSHA requires a lock and a tag on each disconnecting means used to de-energize circuits and equipment that will be worked on. The lock keeps others from turning the power back on, and the tag warns against operating it. A tag alone is allowed only in limited cases, with an extra safety measure.

    Remember: Lockout/tagout: lock it so no one can switch it on, tag it so everyone knows why.

    Checked against OSHA 29 CFR 1910.333, Selection and use of work practices.

  4. 4. The unit of capacitance is the

    • A. ohm
    • B. coulomb
    • C. henry
    • D. farad
    Show the answer to question 4

    Answer: D. Capacitance is charge stored per volt, and its unit is the farad (F), named for Michael Faraday. The henry is the unit of inductance, the ohm is for resistance, and the coulomb is a unit of charge.

    Remember: Farad for capacitors, henry for inductors, ohm for resistors.

    Checked against OpenStax College Physics 2e, 19.5 Capacitors and Dielectrics.

  5. 5. Which of these metals is strongly attracted to a magnet?

    • A. Copper
    • B. Iron
    • C. Aluminum
    • D. Gold
    Show the answer to question 5

    Answer: B. Only certain materials, such as iron, cobalt, nickel and gadolinium, show strong magnetic effects; they are called ferromagnetic. Copper, aluminum and gold show only weak effects that need sensitive instruments to detect.

    Remember: Ferro means iron: iron, nickel and cobalt are the common strongly magnetic metals.

    Checked against OpenStax College Physics 2e, 22.2 Ferromagnets and Electromagnets.

  6. 6. In the circuit shown, a 4-ohm resistor and a 12-ohm resistor are connected in parallel across a 12-volt battery. What is their equivalent resistance?

    +12 VR1 = 4 ΩR2 = 12 Ω
    • A. 16 ohms
    • B. 4 ohms
    • C. 8 ohms
    • D. 3 ohms
    Show the answer to question 6

    Answer: D. For parallel resistors, 1/R = 1/4 + 1/12 = 3/12 + 1/12 = 4/12, so R = 3 ohms. The total is always less than the smallest single resistor (4 ohms). Adding them to get 16 ohms is the series rule, not the parallel rule.

    Remember: Parallel resistance is always smaller than the smallest branch; for two resistors, R = (R1 x R2) / (R1 + R2).

    Checked against OpenStax College Physics 2e, 21.1 Resistors in Series and Parallel.

  7. 7. A current of 2 amperes flows through a 10-ohm resistor. How much power does the resistor give off as heat?

    • A. 5 watts
    • B. 20 watts
    • C. 40 watts
    • D. 200 watts
    Show the answer to question 7

    Answer: C. Power in a resistor is P = I squared x R = 2 x 2 x 10 = 40 watts. Forgetting to square the current gives 20 watts. The voltage across the resistor is 20 volts, and 20 V x 2 A also gives 40 watts.

    Remember: P = I squared x R: doubling the current makes four times the heat.

    Checked against OpenStax College Physics 2e, 20.4 Electric Power and Energy.

  8. 8. The 120-volt rating of a standard U.S. household outlet refers to its

    • A. voltage at the power plant
    • B. rms (effective) voltage
    • C. lowest voltage
    • D. peak voltage
    Show the answer to question 8

    Answer: B. AC voltages are quoted as rms values; household electricity of 120 V AC means the rms voltage is 120 V. The peak is higher, about 170 V, as the voltage swings back and forth. Power lines carry much higher voltages than this.

    Remember: AC ratings are rms values; the peak is about 1.414 times the rms value.

    Checked against OpenStax College Physics 2e, 20.5 Alternating Current versus Direct Current.

What Electronics Information practice test 2 covers

15 questions in 10 minutes, the length and time limit of the Electronics Information subtest on the computer ASVAB. 2 of them are asked with a diagram. This subtest does not count toward your AFQT; it feeds the scores the services use for jobs. Test 2 spreads its questions over 12 topics:

TopicQuestions in test 2
Current, voltage and resistance1
Ohm's law2
Electrical safety2
Components2
Magnetism and induction1
Series and parallel circuits1
Electrical power1
AC and DC1
Meters and tools1
Schematic symbols1
Diodes and transistors1
Wire and wiring1

Questions and time limit: officialasvab.com, What to Expect, read October 3, 2026. The questions are original practice material; the topic names are this site's.

The other Electronics Information tests, and test 2 of the other subtests

What the Electronics Information subtest covers, how it is used and the questions people ask about it are on the Electronics Information practice test page. The format of all ten subtests and how the AFQT is scored are on the ASVAB practice test hub.

All five Electronics Information tests

Practice test 2 of the other subtests

Keep going

officialasvab.com (What to Expect), read October 3, 2026, for the number of questions and the time limit. The questions are original.

Results are estimates. Always verify with your finance office.

Reviewed by Guilherme Correia · Military Toolkit editorial

Military Toolkit is not affiliated with the Department of Defense or the ASVAB testing program. The questions are original practice material, not ASVAB questions.